VISUO XS809HW user manual - drones

1 AGES: 14 +. USER manual . HIGH PERFORMANCE 4-CHANNEL CAMERA QUADCOPTER. Read these instructions carefully before using the appliance and save them for future reference, COMPONENTS: Flip Button Speed Button Take-off/Landing UpiDown and Forwardieackward and Turn LeftiTur LeftsidetRightside Lever Right Lever Take Photo Trim Butto One key Return Button Take Video Headless function Emergency Button Power Switch 2_SETTING UP THE CONTROLLER I DRONE: INSTALLING THE CONTROLLER BATTERIES. the battery cover, and insert 3 'AA batteries. making sure you Insert them following the correct polarity as shown. 2. Re-attach the battery cover t 1. Battery Cover NOTICE: 1. Malays have an WO to lostall the Nineties 2. Always trse Moline Batteries 3. Never rrix old and new batteries 3 X AA(LR06). Batteries THE ARMS. FOLD THE ARMS AS THE ORDER OF NUMBER AS THE PICTURE SHOW. 1. THE PROTECTOR.

2 Pull the accessory as Pict and Press the Locking plate on the protector, as the same time push-in the protector as , the protector is installed finish. Finish}. 5_CHARGING YOUR DRONE BATTERY: BATTERY WARNING. Lithium Polymer batteries can expand, burst or catch fire if used incorrectly, causing both property damage and or personal injury, It is essential that you follow all the included instructions and safety warnings in full. The manufacturerr distributors and retailers will assume no liability for the failure to comply with these safety instructions and warnings. IN WHEN CHARGING: 1) The battery must be removed from the product before charging. 2) If the battery has just been used, please let it cool down to room temperature before charging. 3) Charging must only be undertaken by an Adult, and only using the charger included with this product. 4) Always charge the battery on a non flammable heat resistant surface with non flammable surroundings.

3 5) Connect the battery to the USB charging cable 8) Connect the USE Charging cable to your USB Charging devices. The RED LED on the battery will light up while charging, and will Turn Off once the battery is fully charged. It takes around 90-120 minutes to fully charge the battery. Never continue to charge the battery after the RED LED have Turned Off. 7) Lithium Polymer batteries do not last forever. If your battery becomes damaged in a crash or no longer charges properly, immediately replace it with a new battery. To prolong the life of your battery. it is always best to retain a bit of charge in your battery prior to charging it, Remark: Only USE charging cable that inside packaging can be used for charging. CAFE FLIGHT ENVIRONMENT: sure the surrounding area is free of all people, pets or other obstacles before you start to fly. Drone is designed for Outside flying.

4 Or Indoors if you have enough space. Do not use in strong wind. 3. Leave meters between you and the Drone at all times. 2. 7. SETTING UP THE SIGNAL CONNECTION: . AVA " . OFF OFF. 0 D 00 . 1 0 6. a l ' : 61f e VP, R9,1. o sco . 46-46. 91141.. I r. "maw .. r pc66 %%%%V O 090. *COO. ON ON. VW Laos MAW AM,".. ui ry--- O \. Inset the batten, to the battery housing. (see frig picture). Turn on the power switch of the Drone - the LED's Step 'I on the Drone will start to !Dash. Place the Drone down on a flail surface, making sure the drone ts facing away from you. 1. thCALITION1 Step Press down the controller Power Switch to turn on the power. The controller make two short BEEP mind and the red LED will flash. To pair the signals of the Vision Drone and the Controller. you must RAISE We UP/CON Lever on the controller all the way to the TOP, It MI make one short BEEP sound_ And then LOWER it all the way to the BOTTOM, It will make one tong BEEP sound- The next time you RAI $E the LIRIDOWN Lever the Drone will lift into the air.

5 The throttle stick to lowest point Step 3. rlrehtlah Always Trun of the POWer Switch of the Drone after flight, 141414" I WAYA l e 411.. Z4Z .n , aw ON. AM OW/. power switch Step 4. Always turn the controller or after flight, and remove all batteries it leaving un-used for a Long period of time. 3. : Tip: Below operation only available for allitude hold version. START YOUR FIRST FLIGHT: Push both controH levers to the positions shown in the picture, and hold them for a few seconds. The lights on the drone will start to motor start working. AUTO-HOVER: Press the " take-off Land " button (1) once, the drone automatically goes up to air and stays at a height of around that push the left stick to keep the drone at any height you wants. Press the " take-off /Land " button again, the drone will slowly goes down to the floor and finally the motors stop spinning. Emergency Button: in case the drone is to crash against the wall or hit the tree, you can Press the " Stop button (2) , at the same time, the motors will stop spinning at once and the drone falls to the floor immediately.

6 Make sure there is no people below the drone. CONTROL: PLEASE USE THE CONTROLLER TO PRACTICE SIMULATED FLIGHTS BEFORE YOU ACTUALLY TAKE THE Drone IN THE AIR FOR THE FIRST TIME. Place the Drone on a flat surface. making sure the Yellow LED Lights is facing away from you. When you push Up on the ,_. r When you push Left on the Urkraown Lever the Cirope T grit I. Ascanding . r-- will start to go Up (please do trris slowly ai first till you learn Ihe sensitivity). When you 1 .. ; .. It' o N, Turn Li'fliTUrri Right Lever the Drone will start to spin Leh_ When you A. /. 4. , .._. ,_.. oo . push Right on the Turn 0. Des7encrino push Down an the Up/Down , .. Lettrrurn Right Lever the ./` ..,.. Lever the Drone will Drone will start to Turn lilt I; start to go Down spin Right When you push Forward on the -_. I Forward/Backward Lever the Lett . Flight . racward Drone will stari to fly sEdimard fly <=I.

7 Forward {please do this slowly -- , .. 11 s id ewar d fly CO ,'. ''''-'4 , - ..1 L. at lint MI you learn the " '. sensitivityy Wren you push .. -.: ..1. ''' When you push Leh on the Bank Lehitlank - Backwards on the Forward!' . Reit Levee the Drone will start to Bank Backward BaCkward Lever the Left (prease do this slowly at first till you learn the sensorty). Drone will start to When you push Right on the Bank LeftiBahk Right Lever the '[1 fty Backwards. Drone will stIri lo Bark Right TIP: It is much easier when you start to learn to fly the Drone. to ignore Turn Right Turn Left. By using Up/Down. Forward/Backward, Bank Left/Bank Right, the Drone will still be able to fly anywhere. 10. HOW TO DOA 360 FLIP: 'take sure the Drone is flying at least 3 meters above the floor, or 3 meters bellow a ceiling. 2-Press the Flip button on the controller, The controller will make a "Beep".]}

8 Sound, then flick the right hand lever in any direction, and the Drone will flip in that direction. 3-You may need to push Up on the Llp/Down Lever after the flip, if your battery is low on power in order to keep the Drone high in the air after the Flip_. : SPEED CONTROL: When you first turn on your Drone, it is set to 25% speed, you will hear ONE. beep. When you press the SPEED BUTTON], you will hear TWO beeps and the speed will be increased to 50%. Pressing the SPEED BUTTON again you will hear THREE beeps and the speed will increase to 100%. Pressing again will bring you back to 25% speed and you will hear ONE beep. Always learn to fly at 25%. speed, and then you can increase it as you get better at flying. 4. ADJUSTMENT SECTION: When you lift your Drone into the air, and don't use any of the other direction levers, your Drone should simply hover in one spot without moving in any other direction.

9 If however it doesn't, you can follow the bellow instructions to TRIM your Drone back to a perfect hover. TRIMMING is always needed before your first flight 4414. No #0,,,.. 414 . if your Drone ba nks to the Left.. keep pressing the Bank Left'Bank Right Trim Button to the Right till the a . li 111 Drone stops banking. " O. 41- ii, If your Drone banks to the Right, --. "41, 1111 keep pressing the Bank Left'Bank Right ; Trim Button to the Left tit' the 1 0 .. 0e 1 Drone stops banking. ' e 1. , .0 4 11/4- '1164- AO". No ..---- If your Drone flies Backwards, .. , t . 'NO keep pressing the Forward/Backwards , . Trim Button Up tili the i ill Drone stops flying Backwards, e l',.. If your Drone flies Forwards, keep pressing the Forwarcheackwards Trim Button Down till the Drone stops flying Forwards. TRIM FUNCTION: Push both contcoll levers to the positions shown in the picture, and hold therm for a few seconds_ The lights on the drone will start to flash_ Now the quadcopter is recovered to its original factory setting and ready to fly again.

10 5. AND ONE KEY RETURN FUNCTION: function: key return function: Press the Trim Slider button left, Press the Trim Slider button Right, you will get into compass mode you will get into one key return mode. quit from compass mode To quit the mode by Press the same by Press the same slider button. slider button_. 15. EXTRA INSTRUCTION manual FOR CAMERA DRONE FUNCTION: USING THE CAMERA. 'WV/on .4"tii% OFF. II CCL9. /- Stepri: Insert the memory card Step 2: Turn on the the Power Step 31 The four light will show on into the camera_ You must make Switch of the Drone as the camera whenever the drone is sure you insert the memory card you would for any normal flight. in use The Two tail light will flash the correct way up (see picture). once when you take a photo. and If you insert the memory card up it will Keep flash when taking a video. side down it get stuck and your camera will not work.