Example: biology

Water Repellent Wood Preservative Do Not Dilute …

WOODLIFE 111. Water Repellent Wood Preservative Product Data Sheet Woodlife is Inside . Do Not Dilute FOR INDUSTRIAL USE ONLY. PRODUCT USE PRODUCT ACCEPTANCE. Woodlife 111 is a unique blend of Water This product is a wood Preservative Repellent and wood Preservative ingredients registered for prevention of decay, rot and developed for the protection of wood products other fungi in wood products for above in above ground exposures. Woodlife 111 ground use (EPA Reg. No. 60061-103;. was developed to treat millwork, shingles, EPA Est. No. 60061-MO-1; Applicable State siding, plywood, hardboard, flakeboard, Registrations). This product is recognized structural lumber, fences, and other wood by WDMA for its Hallmark Certification products. Woodlife 111 can be used in the Program. treatment of pine and non-pine sash and other millwork components to meet the Hallmark We recommend effective termite control program of the WDMA.

WOODLIFE® 111 Water Repellent Wood Preservative Product Data Sheet Do Not Dilute FOR INDUSTRIAL USE ONLY Woodlife is …

Tags:

  Water, Woods, Repellent, Water repellent wood preservative do not dilute, Preservative, Dilute, Water repellent wood preservative, Do not dilute

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of Water Repellent Wood Preservative Do Not Dilute …

1 WOODLIFE 111. Water Repellent Wood Preservative Product Data Sheet Woodlife is Inside . Do Not Dilute FOR INDUSTRIAL USE ONLY. PRODUCT USE PRODUCT ACCEPTANCE. Woodlife 111 is a unique blend of Water This product is a wood Preservative Repellent and wood Preservative ingredients registered for prevention of decay, rot and developed for the protection of wood products other fungi in wood products for above in above ground exposures. Woodlife 111 ground use (EPA Reg. No. 60061-103;. was developed to treat millwork, shingles, EPA Est. No. 60061-MO-1; Applicable State siding, plywood, hardboard, flakeboard, Registrations). This product is recognized structural lumber, fences, and other wood by WDMA for its Hallmark Certification products. Woodlife 111 can be used in the Program. treatment of pine and non-pine sash and other millwork components to meet the Hallmark We recommend effective termite control program of the WDMA.

2 Products such as Timbertreat ICP-5 to be combined with this product for use in Woodlife 111 is a clear penetrating, Termite Hazard Zones. nonswelling, paintable, Water Repellent wood Preservative . It helps control the growth of Contact your local Kop-Coat specialist to decay fungi, staining fungi, surface mold and determine which other lumber protectants mildew, to meet the WDMA Industry Standard and additives can be used in combination for a Water Repellent Preservative (WDMA with this product. Standard ). It stabilizes wood against the effects of moisture and reduces dimensional PHYSICAL PROPERTIES. changes that can cause swelling, warping and splitting. Weight per Gallon:.. Flash Point:..105 F. DIRECTIONS FOR USE % VOC*:..98% STORAGE & DISPOSAL. Freeze/Thaw Stable:..yes Store and dispose of the product in Machine, cut, glue and sand wood as Minimum Storage Temperature:..40 F. accordance with all Federal, State and local desired before treating.

3 Do not use over Max Storage Temperature:..100 F. laws and regulations. See product label for previously finished or stained wood without additional information. stripping off the old finish. Do not use steel Physical properties of end-use treatments wool. Wood must be clean and dry before will vary based on additives and other treatment. The temperature of the treating components added to the solution. solution, wood and surrounding air must be ENVIRONMENTAL, HEALTH &. above 40 F ( C). Apply by immersion, *Check with local authorities on VOC SAFETY. flood coat, spray or brush. Do not use high designations. pressure spray. Any surface cut after the first Please refer to the product's label and Material treatment should be re-treated in accordance QUALITY CONTROL & QUALITY Safety Data Sheet for this information. with WDMA IS-4. Millwork and other items ASSURANCE. to be painted should be treated to achieve a retention of 125 ppm total active ingredients.

4 For medical emergencies, Active ingredient concentration of solutions The treatment should be completely dry and may be monitored by use of x-ray contact 1-800-548-0489. odor free before glazing, painting, or fluorescence methods as well as HPLC. varnishing or further processing. Allow 24 to 48 hours under average temperature and Independent labs can conduct analyses humidity conditions for drying. Forced heat for you. Kop-Coat also offers analytical PACKAGING. drying is a good method to accelerate drying. services for its products to help you Some species and types of wood products maintain your program. Bulk tank truck may take longer to dry. 55 gallon steel drums Contact your local Kop-Coat specialist for 5 gallon pails Contact your local Kop-Coat specialist for additional QC/QA information. recommended concentration, application and adhesion testing procedures to help you . Woodlife and Timbertreat are registered achieve your treatment requirements.

5 Trademarks of Kop-Coat, Inc. For more information contact: 436 Seventh Avenue 1850 Koppers Building Pittsburgh, PA 15219. e-mail: APRIL 2008.


Related search queries