Example: tourism industry

XC13 1.5-5 TON AIR CONDITIONERS AIR ... - …

AIR CONDITIONERSXC13 ELITE SeriesR-410A Bulletin No. 210741 November 2017 Supersedes August 2017 SEER up to to 5 TonsCooling Capacity - 17,500 to 59,000 BtuhMODEL NUMBER IDENTIFICATIONX C 13 N 024 - 230 - 2 Nominal SEERUnit Type C = Air Conditioner Refrigerant X = R-410 ANominal Cooling Capacity 018 = tons 024 = 2 tons 030 = tons 036 = 3 tons 042 = tons 048 = 4 tons 060 = 5 tonsMinor Revision NumberVoltage 230 = 208/230V-1phase-60hzPRODUCT SPECIFICATIONSR egional StandardsN = North RegionXC13 TON AIR CONDITIONERSXC13 - to 5 Ton Air Conditioner / Page 2 FEATURESWARRANTYC ompressor - limited warranty for ten years in residential

AIR CONDITIONERS XC13 ELITE® Series R-410A Bulletin No. 210741 November 2017 Supersedes August 2017 SEER up to 15.50 1.5 to 5 Tons Cooling Capacity - …

Tags:

  Conditioners, Air conditioners, 5 ton air conditioners air

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of XC13 1.5-5 TON AIR CONDITIONERS AIR ... - …

1 AIR CONDITIONERSXC13 ELITE SeriesR-410A Bulletin No. 210741 November 2017 Supersedes August 2017 SEER up to to 5 TonsCooling Capacity - 17,500 to 59,000 BtuhMODEL NUMBER IDENTIFICATIONX C 13 N 024 - 230 - 2 Nominal SEERUnit Type C = Air Conditioner Refrigerant X = R-410 ANominal Cooling Capacity 018 = tons 024 = 2 tons 030 = tons 036 = 3 tons 042 = tons 048 = 4 tons 060 = 5 tonsMinor Revision NumberVoltage 230 = 208/230V-1phase-60hzPRODUCT SPECIFICATIONSR egional StandardsN = North RegionXC13 TON AIR CONDITIONERSXC13 - to 5 Ton Air Conditioner / Page 2 FEATURESWARRANTYC ompressor - limited warranty for ten years in residential

2 Installations and five years in non-residential other covered components - five years in residential installations and one year in non-residential to Lennox Equipment Limited Warranty certificate included with unit for specific Certified to AHRI Standard 210 rated in Lennox reverberant sound test room in accordance with test conditions included in AHRI Standard in the Lennox Research Laboratory environmental test according to Department of Energy (DOE) test specific models meet the minimum efficiency requirements for DOE Federal Regional Standards in that CONDITIONERS and components within bonded for grounding to meet safety standards for servicing required by ETL and are ETL certified for the and 9001 Registered Manufacturing Quality expanded ratings.

3 See up to through 5 phase power levels as low as 74 air discharge allows concealment behind shrubs at grade level or out of sight on a add-on furnace indoor coils or air handlers provide a wide range of cooling capacities and applications. See AHRI System Indoor Coils and Air Handlers tab sections for shipped completely factory assembled, piped, and wired. Each unit is test operated at the factory ensuring proper must set air conditioner, connect refrigerant lines, and make electrical connections to complete SYSTEMR-410A RefrigerantNon-chlorine, ozone friendly.

4 Pre-charged with Specification FanDirect drive fan moves large air volumes uniformly through entire condenser coil for high refrigerant cooling air discharge minimizes operating sounds and eliminates damage to lawn and motor has sleeve bearings and is inherently totally enclosed for maximum protection from weather, dust and guard constructed of corrosion-resistant PVC (polyvinyl chloride) coated service access accomplished by removal of fan Tube/Enhanced Fin CoilLennox designed and fabricated aluminum tube fins provide maximum exposure of fin surface to air stream resulting in excellent heat collars grip tubing for maximum contact shoulder tubing connections/silver soldering is factory tested under high pressure to ensure leakproof coil is accessible for System Matches - North Region.

5 9 Dimensions ..6 Electrical Wiring ..7 Installation Clearances ..7 Model Number Identification ..1 Optional Accessories ..5 Sound Data .. Usage ..8XC13 - to 5 Ton Air Conditioner / Page 3 FEATURESREFRIGERATION SYSTEM (continued)High Pressure SwitchProtects the system from high pressure conditions that can be a result of fan failure or a blocked/dirty ThermostatFactory installed on the discharge line of the compressor. SPST, power from the compressor when discharge temperature exceeds the factory setting of 220 Liquid Line DrierFactory installed in the liquid line, the drier traps moisture or dirt that could contaminate the refrigerant molecular-sieve bead type Flow ControlUnits applicable to expansion valve systems or RFC systems when matched with specific indoor.

6 Accurately meters refrigerant in control is accomplished by exact sizing of refrigerant metering principle involves matching indoor coil with proper bore size of orifice in metering pressure shortly after compressor stops, unit starts unloaded, eliminating need for additional AccessoriesExpansion Valve KitsMust be ordered separately and field installed on certain indoor units. See TXV Usage Table on Page on or near the vapor line of the indoor coil or on the suction suction line temperature and cycles the compressor off when suction line temperature falls below it s at 29 F and closes at 58 RINGRFCIV METERING SYSTEMRFCIVORIFICEORIFICE BODY(On Coil)

7 SEALNUTSWEATCONNECTIONLIQUIDLINELIQUIDLI NE SCREENLoss of Charge Switch Kit Helps protect the compressor from damage due low refrigerant charge , normally-closed switch, automatic reset switch mounted on liquid line. Refrigerant Line KitsRefrigerant lines (suction & liquid) are shipped refrigeration clean. Lines are cleaned, dried, pressurized and sealed at line fully are stubbed at both available for -060 models and must be field CompressorCompressor features high efficiency with uniform suction flow, constant discharge flow, high volumetric efficiency and quiet consists of two involute spiral scrolls matched together to generate a series of crescent shaped gas pockets between compression.

8 One scroll remains stationary while the other scroll orbits around is drawn into the outer pocket, the pocket is sealed as the scroll the spiral movement continues, gas pockets are pushed to the center of the scrolls. Volume between the pockets is simultaneously the pocket reaches the center, gas is now at high pressure and is forced out of a port located in the center of the fixed compression, several pockets are compressed simultaneously resulting in a smooth continuous compression flank contact, maintained by centrifugal force, minimizes gas leakage and maximizes compressor is tolerant to the effects of slugging and contaminants.

9 If this occurs, scrolls separate, allowing liquid or contaminants to be worked toward the center and gas pulses during compression reduces operational sound motor is internally protected from excessive current and is installed in the unit on resilient rubber mounts for vibration free - to 5 Ton Air Conditioner / Page 4 COMPRESSOR (Continued)Optional AccessoriesCompressor Crankcase HeaterProtects against refrigerant migration that can occur during low ambient Sound CoverA reinforced vinyl compressor cover containing a 1-1/2 inch thick batt of fiberglass open edges are sealed with a one-inch wide hook and loop fastening AccessoriesCompressor Hard Start KitSingle-phase units are equipped with a PSC compressor motor.

10 This type of motor normally doesn t need a potential relay and start conditions such as low voltage, this kit may be required to increase the compressor starting Blower Off Delay RelayDelays the indoor blower-off time during the cooling AHRI System Matches for Ambient KitAir CONDITIONERS operate satisfactorily down to 45 F outdoor air temperature without any additional Ambient Control Kit can be field installed, allowing unit operation down to 30 Heater and Freezestat should be installed on compressors equipped with a Low Ambient Compressor Low Ambient Cut-Off Switch should be added to terminate compressor operation below recommended operation not furnished with unit.


Related search queries