Transcription of YOUR DYNOJET KIT
1 Thank you for purchasing this Dynojetkit. This kit has been developed for amotorcycle which is set to the parameters listed at the right in the Stage description. If your motorcycledoes not meet any of these parametersplease check with DYNOJET before installation. For technical assistancecontact your DYNOJET distributor or callDynojet (800)-992-49932191 Mendenhall Dr. Suite 105 North Las Vegas, NV 89081 TEL: 702-399-1423 FAX: 702-399-14318am-5pm Pacific TimeMonday through FridayWebsite manufacturer and seller make nowarranties express or implied whichextend beyond the description of thegoods contained herein. Any descriptionof this product is for the purpose ofidentifying it and shall not be deemed tocreate an express Models Only2003-2009 Honda VTX1300S,C,R,T Stage 1 For mildly tuned machines using the stock airbox,with stock or K&N filter.
2 May also be used with agood aftermarket exhaust systemThis graph shows a typical gain with a DYNOJET jet kit. WARNINGNO SMOKING!NO OPEN FLAME!WHILE INSTALLINGYOUR DYNOJET KITP arts List1 Main JetDJ1851 Main JetDJ1901 Main JetDJ1951 Main JetDJ2001 Fuel NeedleDNO7671 Slide SpringDSP0121E-clipDE00011 Adjusting ONE INSTRUCTIONSFig. AFig. BPlace E-clipin groove #3from the top1. Remove the vacuum slide from the carb. Remove the stock needle andspacers, noting the order of assembly (Fig. A).2. Install the DYNOJET needle on groove #3 from the top. Use all stock spacers(Fig. A). Install the small DYNOJET washer above the E-clip. Install the Dynojetslide spring (DSP012) in place of the stock slide spring.
3 After installing the slidein the carb be sure to check slide movement manually before air box Remove the stock main jet and replace with the DYNOJET main jet provided. Ifyou are running the stock exhaust use the DJ190 main jet. If you are using anaftermarket exhaust or slip-on with a high flow baffle use the DJ195 main jet. Besure that the jet you are changing is the main Locate the fuel mixture screw (Fig. B). Using the tool provided (DT009),carefully turn the mixture screws clockwise until lightly seated, then turn back out2-1/2 jetlocationNOTE:When using a K&N stock replacment air filter, install theneedle on groove #4 and set the mixture screw at turns out.
