Programmable Dc Electronic Load Models
Found 8 free book(s)Smith Meter AccuLoad IV
info.smithmeter.comProgrammable Inputs/Outputs AccuLoad ST, QT, and MMI The AccuLoad ST and QT models are explosion-proof designs with an integrated 8.4-inch color touchscreen. AccuLoad ST, ST-UG3, and N4 Hardware Digital Inputs AC DC Total Standard 5 6 11 Optional A4I 5 16 21 Digital Outputs AC DC Total Standard 11 3 14 Optional (one A4I) 31 3 34
Switchgear Prod Guide0082003 - TNB.COM
www.tnb.comprogrammable electronic self powered controls and high dielectric strength EPDM rubber insulation, to provide compact, light-weight submersible over-current protection. Units include molded-in elbow connection interfaces, trip free mechanism, and are available in single phase and three phase models.
Instrumentation and Control - Energy
www.energy.govCPLD complex programmable logic device CPU central processing unit DC direct current DCS distributed control system DD description document DO dissolved oxygen DOE U.S. Department Energy DSA documented safety analysis DSP digital signal processor DTL diode-transistor logic EDA electronic design automation
hargers 2 kVA and 3 kVA - Victron Energy
www.victronenergy.com3 ) Non -linear load, crest factor 3:1 4 ) At 75 ˚F ambient 5 ) Switches off when no external AC source available 6 ) Programmable relay that can a.o. be set for general alarm, DC under voltage or genset start/stop function AC rating: 120 V/4 A DC rating: 4 A up to 35 VDC, 1 A up to 60 VDC
Orion -Tr Smart DC DC charger isolated - Victron Energy
www.victronenergy.comDC connection Screw terminals Maximum cable cross-section 16 mm² (AWG6) Weight 12 V input and/or 12 V output models: 1,8 kg (3 lb) Other models: 1,6 kg (3.5 lb) Dimensions hxwxd 12 V input and/or 12 V output models: 130 x 186 x 80 mm (5.1 x 7.3 x 3.2 inch) Other models: 130 x 186 x 70 mm (5.1 x 7.3 x 2.8 inch)
EJX430A Gauge Pressure Transmitter
web-material3.yokogawa.comSupply & Load Requirements (Output signal code D, E and J. Optional features or approval codes may affect electrical requirements.) With 24 V DC supply, up to a 550Ω load can be used. See graph below. E-10.5 0.0244 (Ω) Power supply voltage E (V DC) 600 250 R 10.5 16.6 25.2 42 External load resistance Digital Communication range BRAIN and HART ...
EJA430E Gauge Pressure Transmitter
web-material3.yokogawa.comThree or four wire low power 1 to 5 V DC output with HART, linear or square root programmable. HART protocol are superimposed on the 1 to 5 V DC signal. Output range: 0.9 V to 5.4 V DC Failure Alarm For 4 to 20 mA HART / BRAIN (Output signal code D and J) Output status at CPU failure and hardware error; Up-scale: 110%, 21.6 mA DC or more (standard)
LT3757/LT3757A (Rev. G) - Analog Devices
www.analog.comLT3757/LT3757A 1 ev For more information www.analog.com n Wide Input Voltage Range: 2.9V to 40V n Positive or Negative Output Voltage Programming with a Single Feedback Pin n Current Mode Control Provides Excellent Transient Response n Programmable Operating Frequency (100kHz to 1MHz) with One External Resistor n Synchronizable to an External Clock n Low …