Current Active Standards - Society for Protective Coatings

SSPC-SP 8 : Pickling . November 1982, ed. rev. November 2004 SSPC-SP 10/ NACE No. 2 Near White Metal Blast Cleaning : January 2007 . SSPC-SP 11 Power Tool Cleaning to Bare Metal November 2013 SSPC-SP 13/NACE No. 6 Surface Preparation of Concrete : May 2018 . SSPC-SP 14 Industrial Blast Cleaning January 2007

  Sspc

FY-22CH-1 21FEB2021 - Naval Sea Systems Command

SSPC-AB 4 may be used as an alternative to obtain NACE 2/SSPC-SP 10 or SSPC-SP 11 cleanliness. 3.1.3.3 Recyclable ferrous metallic abrasive materials conforming to SSPC-AB 3 of 2.5 may be used as an abrasive blast media for steel substrates. Cleanliness of recyclable ferrous metallic abrasive materials must be measured and maintained in accordance

  System, Naval, Command, Sspc, Naval sea systems command

NACE No. 2/SSPC-SP 10 - psubs.org

2.7 SSPC-VIS 1(3) photographs A SP-10, B SP-10, C SP-10, or D SP-10 may be specified to supplement the written definition. In any dispute, the written standards shall take precedence over visual standards and comparators. Additional information on visual standards and comparators is available in Paragraph A4 of Appendix A.

  Cane, Sspc, Nace no, 2 sspc sp 10

Intertherm 50 - AkzoNobel

Oct 30, 2017 · Hand or power tool clean to a minimum St3 (ISO 8501-1:2007) or SSPC-SP3. Note, all scale must be removed and areas which cannot be prepared adequately by chipping or needle gun should be spot blasted to a minimum standard of Sa2½ (ISO 8501-1:2007) or SSPC-SP6. Typically this would apply to C or D grade rusting in this standard. Primed Surfaces

  Sspc, Intertherm, Intertherm 50

DAILY WORK REPORT - STRUCTURAL STEEL PAINTING: FIELD …

steel grit cleanliness - sspc ab2 - total removal only. non-abrasive residue test (% by wt. of work mix sample) oil content visible? lead content (% by weight- weekly test) yes. nocondition before & after surface prep - sspc. condition before surface prep. ... 10/9/2015 7:47:14 am ...

  Sspc

A criteria driven ACL rehabilitation protocol and ... - SSPC

Phase 3: Running, Agility, and Landings 10 Phase 4: Return to Sport 13 Phase 5: Prevention of Re-injury 22 Q & A with Randall Cooper 26 Bibliography 28 Contents. 3COOPER Randall Cooper is an experienced sports physio who consults at the Olympic Park Sports Medicine Centre in Melbourne, and is a

  Sspc

PUB. 135 - INSPECTION OF FABRICATED STRUCTURAL STEEL …

PUB 135 (10-19) 2. Verify that fabrication is in accordance with accepted shop drawings, specifications and any other contract requirements. 2.1. The specifications require accepted or accepted as noted shop drawings before fabrication. Notify the fabricator that any fabrication performed prior to receipt of the acceptedor