Dell EMC PowerEdge RAID Controller Command Line …

← Back to document page

Dell PowerEdge RAID Controller 9, 10, and 11Command Line Interface Reference GuideNovember 2022Rev. A06Notes, cautions, and warningsNOTE: A NOTE indicates important information that helps you make better use of your : A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoidthe : A WARNING indicates a potential for property damage, personal injury, or death. 2018-2022 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its trademarks may be trademarks of their respective 1: 5Chapter 2: Accessing the Command 6Using CLI commands from Windows Command 6Using CLI commands in 6Using CLI commands in 6Chapter 3: Working with the PERC Command Line Interface 7System show 8Controller and set Controller properties 8Controller show 12Controller background tasks operation 13Consistency 15Controller security 16Flashing Controller firmware 17Controller cache 18Controller profile 18HBA Controller 18Drive 21Drive show 21Missing drives initialization 23Set drive state 23Locate drives 24Prepare to remove drives switch 25Drive security 26Drive erase 27Rebuild drives 28Drive copyback 29Hot spare drive 30Virtual drives 31Add virtual drives 31Delete virtual drives 33Delete non-RAID drive show cache virtual drive properties 35Virtual drive initialization drive erase 38Virtual drive migration 39Cont

number of controllers, the host name, the operating system information, and the overview of existing configuration. perccli show all. This command shows the list of controllers and controller-associated information, information about the drives that need attention, and advanced software options. perccli show ctrlcount

  Controller, Arid, Perccli