DIGITAL PANEL MOUNT METER - Transducer Techniques

← Back to document page

DPM-3OPERATOR MANUALPLUG AND PLAY IEEE COMPLIANTTechniquesTransducerRDIGITAL PANEL MOUNT METER4006497 - 2 - TABLE OF CONTENTS 1. TEDS IEEE INTRODUCTION ........................................ .................................. 3 2. GENERAL INTRODUCTION ........................................ ........................................ ....... 3 3. RECEIVING & UNPACKING ........................................ ........................................ ....... 4 4. SAFETY CONSIDERATIONS.

rear panel (see figure below). This will unhook the rear panel from the case. Rear Panel REMOVING THE ELECTRONICS With the rear panel removed, grasp the power supply board to the left and signal condi-tioner board to the right, and carefully slide the electronic assembly out through the rear of the case (see figure below). INSTALLING NEW OPTION ...

  Rear, Panels, Rear panel