Transcription of DIGITAL PANEL MOUNT METER - Transducer Techniques
{{id}} {{{paragraph}}}
DPM-3 OPERATOR MANUALPLUG AND PLAY IEEE COMPLIANTT echniquesTransducerRDIGITAL PANEL MOUNT METER4006497 - 2 - TABLE OF CONTENTS 1. TEDS IEEE INTRODUCTION .. 3 2. GENERAL INTRODUCTION .. 3 3. RECEIVING & UNPACKING .. 4 4. SAFETY CONSIDERATIONS .. 4 5. CONNECTOR WIRING INFORMATION .. 6 6. MECHANICAL ASSEMBLY .. 8 7. FRONT PANEL SETUP KEYS .. 10 8. ENABLING AND LOCKING OUT MENU ITEMS .. 12 9. TEDS SIGNAL CONDITIONER IN TEDS MODE .. 13 10. SETUP OF NON-TEDS TRANSDUCERS .. 17 11. METER SCALING BY APPLYING KNOWN LOADS .. 18 12. TEDS SIGNAL CONDITIONER WITH NON-TEDS TRANSDUCERS.
rear panel (see figure below). This will unhook the rear panel from the case. Rear Panel REMOVING THE ELECTRONICS With the rear panel removed, grasp the power supply board to the left and signal condi-tioner board to the right, and carefully slide the electronic assembly out through the rear of the case (see figure below). INSTALLING NEW OPTION ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}