DIGITAL PANEL MOUNT METER - Transducer Techniques
DPM-3OPERATOR MANUALPLUG AND PLAY IEEE COMPLIANTTechniquesTransducerRDIGITAL PANEL MOUNT METER4006497 - 2 - TABLE OF CONTENTS 1. TEDS IEEE INTRODUCTION ........................................ .................................. 3 2. GENERAL INTRODUCTION ........................................ ........................................ ....... 3 3. RECEIVING & UNPACKING ........................................ ........................................ ....... 4 4. SAFETY CONSIDERATIONS ........................................ ........................................ ...... 4 5. CONNECTOR WIRING INFORMATION ........................................ ............................. 6 6. MECHANICAL ASSEMBLY ........................................ ........................................ ......... 8 7. FRONT PANEL SETUP KEYS.
Connectors for signal and power are UL-rated screw-clamp terminal blocks that plug into mating jacks on the printed circuit board. Communication connectors can be a USB jack, a single RJ11 jack for RS232, dual RJ11 jacks for RS485, or dual RJ45 jacks for RS485. Note: For wiring color, refer to Load Cell Calibration Certificate or to
Download DIGITAL PANEL MOUNT METER - Transducer Techniques
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: