DRAFTING MANUAL

← Back to document page

Update 69 Gary Whitmire DRAFTING MANUAL Gears (Bevel and Hypoid) DRAFTING Practice Section Page 1 August, 2003 Genium Publishing Corporation General This section provides the basis for uniformity in engineering gears drawings and their technical data for gears with intersecting axes (bevel gears), and nonparallel, nonintersecting axes (hypoid gears). It also discusses the method of specifying matched sets on a gear drawing. Purpose It is the purpose of this section to provide formats, nomenclature, and definitions. The minimum data for the various gear types are defined.

Update 69 Gary Whitmire DRAFTING MANUAL Gears (Bevel and Hypoid) Drafting Practice Section 4.9.1 Page 1 August, 2003 Genium Publishing Corporation

  Manual, Drafting, Drafting manual