FEDERAL STANDARD SCREW-THREAD …

← Back to document page

FED-STD-H28A. 28 December 1994. SUPERSEDING. FED-STD-H28. 31 March 1978. FEDERAL STANDARD . SCREW-THREAD standards FOR FEDERAL services . . This STANDARD was approved by the Commissioner, FEDERAL Supply Service, general services Administration, for the use of all FEDERAL Agencies. Beneficial comments (recommendations, addition, deletions) and pertinent data which may be of use in improving this document should be addressed to: Defense Industrial Supply Center (Code DISC-ETT) 700 Robbins Avenue, Philadelphia, PA 19111-5096 by using the self addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.

Dec 28, 1994 · FEDERAL STANDARD SCREW-THREAD STANDARDS FOR FEDERAL SERVICES. This standard was approved by the Commissioner, Federal Supply ... FED-STD-H28/7-Pipe Threads, General Purpose ... AMERICAN SOCIETY OF MECHANICAL ENGINEERS (ASME) PUBLICATIONS

  Federal, American, Services, General, Standards, Engineer, Asme, American society of mechanical engineers, Society, Mechanical, Screw, Thread, Pipe, Federal standard screw thread, Federal standard screw thread standards for federal services, Pipe thread