ISCAR Grades Chart

Grades for Applications and Materials Material Groups Main Applications ISO P ISO H ISO M ISO S ISO K ISO N 1-11 Steel 38-41 Hard Steel 12-14 Stainless

  Chart, Grade, Iscar grades chart, Iscar

Nuances ISCAR - ISCAR Cutting Tools

S.T.SUMO TEC Standard Semi-standard Nuances ISO Couches de revêtements Applications TRONÇONNAGE GORGES USINAGE FRONTAL TOURNAGE ISO FILETAGE PERÇAGE FRAISAGE IC300 REVÊTUE PVD P25-P50 M20-M40 S15-S25 TiN TiCN Nuance tenace micrograins revêtue TiCN/TiN PVD.

  Nuance, Iscar, Nuances iscar

ISCAR Grades Chart - ISCAR Cutting Tools

Grades for Applications and Materials Material Groups Main Applications ISO P ISO H ISO M ISO S ISO K ISO N 1-11 Steel 38-41 Hard Steel 12-14 Stainless

  Chart, Cutting, Grade, Iscar grades chart, Iscar

40,000 - Iscar

MM FF - 2 10-20 37 E MM EFF - 4, 6 8-25.4 38 MM HT - 2 10-20 39 E MM HT-NCSR - 2 12 40 MM HT-NWFR - 2 12 40 MM ETR 30° 6 8-16 41 MM HCR - 2 8-16 General Finishing 43 E MM HRF - 2 8-16 General Finishing 43 E MM HBR - 2 10-25.4 44 E MM EB 30° 2, 4 6-20 45 MM EBA 45° 2 8-25 For Machining Aluminum 45 MM HC 10° 2 7.8-16 47 MM ECU 38° 3 7.7-19.7 ...

ISCAR Grades Chart

A 55% CBN brazed tip, used for finishing hardened steel (45-65 HRc) in continuous cutting. ID5 N01-N10 A PCD brazed tip, suitable for machining aluminum (Si < 12%) and copper alloys and general cutting of nonferrous materials. ID8 N05-N15 PCD grade for milling applications. Ideal for machining nonferrous metals, such as high silicon (>12%)

UNIT 1 INTRODUCTION TO TOOL Introduction to Tool ...

Long Indexable Insert Tool It consists of mechanical tool holder and an indexable insert with top and bottom that can be reground to correct geometry. Regrinding is done by grinding the ends of inserts normal to the side only enough to clean up the cutting edge. Inserts are available in square, rectangular, diamond, round, triangular shapes.

  Introduction, Tool, Indexable, Introduction to tool introduction to tool