ISCAR Grades Chart
DR drills. S.T. IC8150 P01-P30 K05-K15 M05-M15 TiCN Al203 TiN A very hard substrate with a cobalt enriched layer, MTCVD TiCN and a thick Al 2 O 3 CVD coating. Features excellent thermal stability and resistance to chipping and plastic deformation. Recommended for high speed machining of steel at stable or slightly unstable conditions. S.T ...
Download ISCAR Grades Chart
Information
Domain:
Source:
Link to this page:
Documents from same domain
ISCAR Grades Chart
www.iscar.comGrades for Applications and Materials Material Groups Main Applications ISO P ISO H ISO M ISO S ISO K ISO N 1-11 Steel 38-41 Hard Steel 12-14 Stainless
Nuances ISCAR - ISCAR Cutting Tools
www.iscar.comS.T.SUMO TEC Standard Semi-standard Nuances ISO Couches de revêtements Applications TRONÇONNAGE GORGES USINAGE FRONTAL TOURNAGE ISO FILETAGE PERÇAGE FRAISAGE IC300 REVÊTUE PVD P25-P50 M20-M40 S15-S25 TiN TiCN Nuance tenace micrograins revêtue TiCN/TiN PVD.
ISCAR Grades Chart - ISCAR Cutting Tools
www.iscar.comGrades for Applications and Materials Material Groups Main Applications ISO P ISO H ISO M ISO S ISO K ISO N 1-11 Steel 38-41 Hard Steel 12-14 Stainless
40,000 - Iscar
www.iscar.comMM FF - 2 10-20 37 E MM EFF - 4, 6 8-25.4 38 MM HT - 2 10-20 39 E MM HT-NCSR - 2 12 40 MM HT-NWFR - 2 12 40 MM ETR 30° 6 8-16 41 MM HCR - 2 8-16 General Finishing 43 E MM HRF - 2 8-16 General Finishing 43 E MM HBR - 2 10-25.4 44 E MM EB 30° 2, 4 6-20 45 MM EBA 45° 2 8-25 For Machining Aluminum 45 MM HC 10° 2 7.8-16 47 MM ECU 38° 3 7.7-19.7 ...
ISCAR Grades Chart
www.iscar.comA 55% CBN brazed tip, used for finishing hardened steel (45-65 HRc) in continuous cutting. ID5 N01-N10 A PCD brazed tip, suitable for machining aluminum (Si < 12%) and copper alloys and general cutting of nonferrous materials. ID8 N05-N15 PCD grade for milling applications. Ideal for machining nonferrous metals, such as high silicon (>12%)
Related documents
UNIT 1 INTRODUCTION TO TOOL Introduction to Tool ...
www.nitc.ac.inLong Indexable Insert Tool It consists of mechanical tool holder and an indexable insert with top and bottom that can be reground to correct geometry. Regrinding is done by grinding the ends of inserts normal to the side only enough to clean up the cutting edge. Inserts are available in square, rectangular, diamond, round, triangular shapes.