LAB MANUAL for Computer Network

← Back to document page

LAB MANUALforComputer NetworkDEPARTMENT OF ELECTRONICS & COMMUNICATION ENGINEERINGSRI JAYACHAMARAJENDRA COLLEGE OF of different types of Network cables and Practically implementthecross-wired cable and straight through cable using clamping of Network Devices in of Network the computers in Local Area of basic Network command and Network an Initial Switch Configuration7Performing an Initial Router Configuration8Configuring and Troubleshooting a Switched Network9Connecting a Switch10Configuring WEP on a Wireless Router11Using the Cisco IOS Show Commands12Examining WAN Connections13Interpreting Ping and Traceroute Output14Demonstrating Distribution Layer Functions15Placing ACLs16Exploring Different LAN Switch Options17Implementing an IP Addressing Scheme18Examining Network AddressTranslation (NAT)19Observing Static and Dynamic Routing20Configuring Ethernet and Serial Interfaces21Configuring a Default Route22Configuring Static and Default Routes23Configuring RIP24Planning Network -based Firewalls25Configuring aCisco Router as a DHCP ServerEx

2. Click Start, and then click Control Panel. 3. Click Network and Internet Connections. 4. Click Network Connections. 5. Right-click the connection that you use to connect to the Internet. For example, if you connect to the Internet by using a modem, right-click the connection that you want under Dial-up / other network available. 6.

  Then, Modem