PROGRAMMING WORKBOOK

← Back to document page

PROGRAMMING WORKBOOKHAAS AUTOMATION, Sturgis , CA 93030JUNE 1, 2000 JUNE COORDINATE AND INCREMENTAL WITH FUNCTIONS (M CODES).................................. ...............16PREPARATORY FUNCTIONS (G CODES).................................. ...................18MACHINE OF CANNED ADDRESS POSITION COMMANDS (G00)................................... ..........................28INTERPOLATIO N COMMANDS (G01)................................... ..........................29CIRCULAR INTERPOLATION COMMANDS (G02,G03)............................... .30INTERPOLATION START-UP ENDING (G04)................................... ........................................ ..........................42CIRCULAR POCKET MILLING (G12, G13).................................... .................43CIRCULAR POCKET MILLING PLANE SELECTION (G17, G18, G19).................................... ....47INCH / METRIC SELECTION (G20, G21).

PROGRAMMING JUNE 2000 THE COORDINATE SYSTEM The first diagram we are concerned with is called a NUMBER LINE. This number line has a zero reference point that is called an ABSOLUTE ZERO and may be placed at any point along the number line. Horizontal number line The number line also has numbered increments on either side of absolute zero.

  Programming, Reference, Workbook, Programming workbook