Transcription of PROGRAMMING WORKBOOK
{{id}} {{{paragraph}}}
Example: bachelor of science
PROGRAMMING WORKBOOK
PROGRAMMING WORKBOOKHAAS AUTOMATION, Sturgis , CA 93030 JUNE 1, 2000 JUNE COORDINATE AND INCREMENTAL WITH FUNCTIONS (M CODES)..16 PREPARATORY FUNCTIONS (G CODES)..18 MACHINE OF CANNED ADDRESS POSITION COMMANDS (G00)..28 INTERPOLATION COMMANDS (G01)..29 CIRCULAR INTERPOLATION COMMANDS (G02,G03)..30 INTERPOLATION START-UP ENDING (G04)..42 CIRCULAR POCKET MILLING (G12, G13)..43 CIRCULAR POCKET MILLING PLANE SELECTION (G17, G18, G19)..47 INCH / METRIC SELECTION (G20, G21)..51 reference POINT DEFINITION AND RETURN (G28)..52 CUTTER COMPENSATION (G40, G41, G42)..53 CUTTER COMPENSATION EXERCISE # COMPENSATION EXERCISE # LENGTH COMPENSATION (G43)..66 WORK COORDINATE SELECTION (G54-59, G110-129, G52, G53, G92)..67 NON-MODAL COORDINATE SELECTION (G53)..67 ANOTHER WAY TO SEND MACHINE HOME USING G53 CYCLES - CANNED CYCLE (G80)..70 DRILL - CANNED CYCLE (G81) ..71 SPOT DRILL - CANNED CYCLE (G82).
PROGRAMMING JUNE 2000 THE COORDINATE SYSTEM The first diagram we are concerned with is called a NUMBER LINE. This number line has a zero reference point that is called an ABSOLUTE ZERO and may be placed at any point along the number line. Horizontal number line The number line also has numbered increments on either side of absolute zero.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: