STEEL PIPE - Antec Engineering

← Back to document page

STEEL PIPEMEDIUM & HEAVY PIPEMEDIUM & HEAVY PIPE4MANUFACTURING PROCESSGrade C250 pipe , for general mechanical and lowpressure reticulation applications, is manufactured bycold-forming and high frequency Electric ResistanceWelding. The cold-forming process enhances the strength,hardness and surface finish of the pipe and producesproduct to tight dimensional tolerances. pipe is tested byusing non-destructive Eddy Current methods during STANDARDSGrade C250 pipe is manufactured and tested to complywith the requirements of the following specifications:AS 1074 - STEEL tubes and tubulars for ordinary 1163 - Structural STEEL hollow sections(Grade C250, C250LO).AS 4792 - Hot-dipped galvanised coating on ferroushollow sections. Applied by a continuous or a grades with guaranteed impact performancesat 0 C. With impact guaranteed properties, theopportunities for the designer are now enhanced in lowtemperature service environments under AS PROPERTIESMinimum Yield Strength250 MPaMinimum Tensile Strength320 MPaMinimum Elongation in So22%TOLERANCESStraightnessThickness ToleranceDimensional ToleranceLength Tolerance+50mm/-0mmIf tighter tolerances are required, they must be specifiedat the time of order (conditions apply).

LIGHT AND EXTRA LIGHT PIPE 6 Grade C350 MASS AND BUNDLING DATA - Calculated in accordance with AS 1163 Grade C350 Pipe is a …

  Steel, Pipe, Steel pipes