THREAD GAGING REFERENCE GUIDE

← Back to document page

Know your threads, L. S. STARRETT COMPANY121 Crescent Street Athol, MA 01331Telephone (508) 249-3551Fax (508) 249-8495Table of ContentsSECTION 1:Fundamentals of Screw THREAD Technology ................. 4 - 7SECTION 2:Definitions and Terminology ........................................ .. 8 - 11SECTION 3:Gage Design Contacts ........................................ .......... 12 - 13SECTION 4:Technical Considerations ........................................ ...... 14 - 23SECTION 5:Plating, Metric and RFQ ........................................ ....... 24 - 274Screw THREAD DesignationScrew THREAD DesignationScrew THREAD DesignationScrew THREAD DesignationScrew THREAD DesignationEXAMPLE: .3125 - 24 UNJF - 3A (B).3125 = Nominal Diameter = Maximum Major Diameter24= Number of threads per inchUN= Unified National (60 V- THREAD )J= Controlled root radius High Strength(Minor diameter increased from UN to UNJ.)

width of the thread ridge and the thread groove equal. Pitch Line. The pitch line is linear and parallel to the center line of the pitch cylinder. De-fined where thread ridge and thread groove are equal along the length of the thread. Thread Axis. The thread axis is the axis of its pitch cylinder. Actual Size. An actual size is a measured size ...

  Guide, Reference, Thread, Gaging, Thread gaging reference guide