Vertical Installation Technical Specification - James Hardie

← Back to document page

JULY 2018 I NEW ZEALANDVertical InstallationTechnical SpecificationWEATHERBOARDLinea ObliqueContents5 Installation General Fastener durability Fastener size and layout 76 JOINTS Vertical joint Horizontal joint Drainage joint External corner Internal corner 77 FINISHES Preparation Painting Flexible sealant 88 STORAGE AND HANDLING 89 MAINTENANCE 810 PRODUCT INFORMATION Manufacturing and classification Product mass Durability 911 SAFE WORKING PRACTICES 1012 PRODUCT AND ACCESSORIES 1213 DETAILS 14 PRODUCT WARRANTY 391 APPLICATION AND SCOPE Application Scope Details 3 Specific design 32 DESIGN Compliance Responsibility Site and foundation Surface clearances Moisture management Structure Fire rated walls Structural bracing Energy efficiency 43 FRAMING General Timber framing Special framing requirements Tolerances 54 PREPARATION Flexible underl

Insulation capability Climate zone R-value requirement Minimum cavity insulation infill requirement 1 and 2 1.9 m2 ºC/W R2.0* 3 2.0 m2 ºC/W R2.2* Total construction R-value depends on the insulation material used and the framing ratio. The insulation material R-values specified in this table are for studs spaced at 600mm centres

  Insulation