232 Transceiver
Found 7 free book(s)SP3222E / SP3232E Datasheet - MaxLinear
www.maxlinear.comThe SP3222E and SP3232E series are RS-232 transceiver solutions intended for portable or hand-held applications such as notebook or palmtop computers. The SP3222E / SP3232E series has a high-efficiency, charge-pump power supply that requires only 0.1µF capacitors in 3.3V operation. This charge pump allows the SP3222E
EX2300 Switch Hardware Guide - Juniper Networks
www.juniper.netSep 02, 2021 · Remove a Transceiver. 225. Remove a QSFP28 Transceiver. 227. Install a Transceiver. 229. Install a QSFP28 Transceiver. 232. Maintain Fiber-Optic Cables. 234. Connect a Fiber-Optic Cable. 234. Disconnect a Fiber-Optic Cable. 235. How to Handle Fiber-Optic Cables. 236. Troubleshooting Hardware. Troubleshooting EX2300 Components. 239
MAX3160/MAX3161/MAX3162 +3.0V to+5.5V, 1µA, RS-232/ …
datasheets.maximintegrated.comas a 2TX/2RX RS-232 interface or a single RS-485/422 transceiver. The MAX3162 is configured as a 2TX/2RX RS-232 interface and a single RS-485/422 transceiver simultaneously. All devices incorporate a proprietary low-dropout trans-mitter output stage and an on-board dual charge pump to allow RS-232 and RS-485/422 compliant perfor-
© Copyright 2015 2021 Xilinx
www.xilinx.com6. The GTY transceiver line rate in the F1924 footprint is package limited to 16.3Gb/s. Refer to data sheet for details. 7. These 52.5x52.5mm packages have the same PCB ball footprint as the 47.5x47.5mm packages and are footprint compatible. 8. GTYs in quads 224-230 and 232 are limited to 16Gb/s. Page 4 XMP103 (v2.0)
CP2102/9
www.silabs.com232 designs to USB using a minimum of components and PCB space. The CP2102/9 includes a USB 2.0 full-speed function controller, USB transceiver, oscillator, EEPROM or EPROM, and asynchronous serial data bus (UART) with full modem control signals in a compact 5 x 5 mm QFN-28 package. No other external USB components are required.
USBXpress™ Family 1.2 Specification) - Silicon Labs
www.silabs.comupdating RS-232 designs to USB using a minimum of components and PCB space. CP2102N includes a USB 2.0 full-speed function controller, USB transceiver, oscillator, and Universal Asynchronous Receiver/Transmitter (UART) in packages as small as 3 mm x 3 mm. No other external USB components are required for development. All cus-
Dell EMC PowerSwitch S4100–ON Series Installation Guide ...
dl.dell.comtransceiver ports. Avoid exposure to laser radiation. Do not stare into open apertures. NOTE: Read this guide before unpacking the switch. For more information, see Unpack the switch. Topics: • Related documents • Information symbols. Related documents. For more information about the S4100-ON Series, see the following documents: