Contacting Conductivity Sensors
Found 4 free book(s)November 2020 Rosemount 400 and 400VP
www.emerson.comThe Rosemount 400/400VP contacting conductivity sensors are intended to measure electrolytic conductivity in clean water applications. You can configure these sensors with a 0.01/cm, 0.1/cm, or 1.0/cm to accommodate varying levels of conductivity. The sensors are available with either an integral cable connection or Variopol (VP6) connector.
THEORY AND APPLICATION OF CONDUCTIVITY
www.emerson.comContacting Conductivity Most contacting conductivity sensors consist of two metal electrodes, usually stainless steel or titanium, in contact with the electrolyte solution. See Figure 3. The analyzer applies an alternating voltage to the elec-trodes. The electric field causes the ions to …
Conductivity: Water Quality Assesment - IJERT
www.ijert.orgThere are two types of conductivity sensors: electrodes (or contacting sensors) and toroidal or inductive sensors. Electrode sensors contain two, three, or four electrodes. The conductivity is directly proportional to the cell constant and inversely proportional to the resistance. The
Orbisint CPS11 / CPS11D - Endress+Hauser
portal.endress.comConductivity min. 50 μS/cm pH range " Caution! Danger of electrode damage Do not operate the electrodes in applications outside the given specifications! IP 67: GSA plug-in head (with closed plug-in connection) IP 68: TOP68 plug-in head, autoclavable up to 135 °C (275 °F), 1 m (3.28 ft) water column, 50 °C (122 °F), 168 h