Flash utility
Found 4 free book(s)Updating the BIOS with the Q-Flash Utility - GIGABYTE
www.gigabyte.com• Q-Flash only supports USB flash drive or hard drives using FAT32/16/12 file system. • If the BIOS update file is saved to a hard drive in RAID/AHCI mode or a hard drive attached to an independent IDE/SATA controller, use the <End> key during the POST to access Q-Flash. 2. Select Floppy A and press <Enter>. Q-Flash Utility v2.05
How to Make a Bootable Flash Disk and to Flash Bios
storage-asset.msi.com2. Extract the compressed file containing the BIOS file and the flash utility. Copy all files to a bootable USB flash drive. 3. Insert the USB flash to the USB port. 4. Press “DEL” key after the power-on to enter the BIOS, go to “Boot” page and set the “Boot mode select” to “Legacy” mode. Then press “F10” key to
Displaying a custom logo during bootup of HP commercial ...
www.hp.comERPEPLOGO.EXE Utility Use the EREPLOGO.EXE utility for HP commercial notebook systems running BIOS 08, BIOS 09, or BIOS 2011. Systems running BIOS 2012 cannot use the EREPLOGO.EXE utility. You must run EREPLOGO.EXE from a DOS environment. You cannot run EREPLOGO.EXE from Windows. The most
Cisco 200 Series 8-port Smart Switches Administration Guide
www.cisco.comStarting the Web-Based Switch Configuration Utility Cisco Small Business SG200 Series 8-port Smart Switch 9 1 Launching the Utility To open the web-based switch configuration utility: STEP 1 Open a web browser. STEP 2 Enter the IP address of the switch that you are configuring in the address bar on the browser, and then press Enter.