Pendent Sprinklers
Found 5 free book(s)SPRINKLER HEAD - NAFFCO FZCO
www.naffco.comthe Upright Sprinklers, and in the Pendent position for the Pendent Sprinkler, Pendent Recessed Sprinkler. Step 2 - Use only a non-hardening pipe joint compound or tape seal. Apply only to the male threads. Step 3 - Hand tighten the sprinkler into fitting. Step 4 - For Upright and Pendent Sprinklers, use a standard wrench.
ESFR PENDENT TECHNICAL DATA SPRINKLER VK510 (K25.2)
www.vikinggroupinc.comFor Viking ESFR Pendent Sprinklers, refer to the Installation Standards (e.g., NFPA 25) and the Authorities Having Jurisdiction for the specified period of time after which testing and/or replacement is required. Sprinklers that have operated cannot be reassembled or reused, but must be replaced. When replacing sprinklers, use only new sprinklers.
Pocket Guide to Automatic Sprinklers
www.fmglobal.comUpright sprinklers are designed for installation on the top of sprinkler piping, with the deflector positioned above the orifice . This is the most common orientation for control-mode sprinklers . Pendent sprinklers are installed on the underside of piping, with the deflector located below the orifice . This orientation
Models F1 Series Standard Response Sprinklers
www.reliablesprinkler.comModel F142, F1XLH & F128 Upright & Pendent Sprinklers Installation Wrench: Model W2 Sprinkler Wrench Installation Data: Nominal Orifice Thread Size Nominal K-Factor Sprinkler Height Approval Organization Sprinkler Identification Number (SIN) US Metric Upright Pendent Standard-Upright (SSU) and pendent Deflectors Marked to Indicate Position
ESFR PENDENT TECHNICAL DATA SPRINKLER VK500 (K14.0)
www.vikinggroupinc.comViking VK500 ESFR Pendent Sprinklers may be used in the protection of ordinary types of storage. However, they are primarily intended to protect the following types of stor-age, which tend to produce severe-challenge fires: palletized and solid pile storage and single, double, multiple row, and portable open rack storage (no open-top containers