Standard Taper
Found 4 free book(s)Fitting Threads - Parker Hannifin
www.parker.comThis is an American standard taper thread which fits into the matching taper port. Sealing is provided by a pre-coating on the thread. Example: 1/8 NPT thread = 1/8 NPT These ISO-profile threads are parallel and are fit into the matching parallel port. Sealing is provided by an O-ring or a sealing washer.
SURFACE PREPARATION AND PROTECTIVE COATING - …
www.standard.noof the standard. Feathered A gradual taper in thickness from a coated surface to an uncoated surface. Generic type Coatings with the same type of binder and active filler (e.g. zinc). Used in this document for shop primers. Holiday A discontinuity in a coating, which exhibits electrical conductivity, when exposed to a specific voltage.
STANDARD SPECIFICATION FOR HUBLESS CAST IRON SOIL …
www.cispi.orgopenings in fittings shall have taper pipe threads in accordance with ANSI/ASME Standard B1.20 7.2.4 Internal threads shall be chamfered at the entering end approximately to the major diameter of the thread, at an angle of approximately 45° with the axis of the thread for easy entrance in making a joint and for protection of the thread. The
STANDARD SPECIFICATIONS - California
ppmoe.dot.ca.gov1.4. Industry-standard terms 2. Elimination of: 2.1. Language variations 2.2. Definitions for industry-standard terms 2.3. Redundant specifications 2.4. Needless cross-references Because of the transition, some terms or clauses used in Division I are different from those used in other divisions and in other Contract parts.