ISO Standards for use in the oil & gas industry

ISO 3183 Steel pipe for pipeline transportation systems ISO 12490 Actuation, mechanical integrity and sizing for pipeline valves ISO 12736 Wet thermal insulation coatings ISO 12747 Pipeline life extension ISO 13623 Pipeline transportation systems ISO 13847 Welding of pipelines ISO 14313 Pipeline valves ISO 14723 Subsea pipeline valves

  Steel, Pipeline

Guidelines for the Design of Buried Steel Pipe July 2001

of Buried Steel Pipe July 2001 (with addenda through February 2005) A public-private partnership to reduce risk to utility and transportation systems from natural hazards ... Figure 8.2-1 Pipeline Thaw Settlement Scenario .....32 Figure 8.2-2 Finite Element Model of Pipeline Settlement.....33 Figure 8.3-1 Buried Pipeline Subject to Vertical ...

  Guidelines, Design, Steel, Pipe, Pipeline, Buried, Guidelines for the design of buried steel pipe

CATHODIC PROTECTION DESIGN

conditions of the steel (i.e. uncoated, coated, concrete reinforcing steel, pipeline). 7 5.1.1 Uncoated Steel Three design current densities are given: initial, final, and average. Initial This is the current density required to effect polarization of the initially exposed bare steel surface. It assumes some atmospheric rusting and/or

  Steel, Pipeline

Fisher Large ED/EWD and ET/EWT Valves NPS 12 through 30

resistance of the standard hardened stainless steel trim means long-lasting service. Easy Maintenance— The valve can stay in the pipeline during removal of trim parts for inspection or maintenance. Large ET and ED Valves D103554X012 Product Bulletin 51.1:ET/ED (Large) April …

  Steel, Pipeline

Welding Pressure Pipeliners and Piping Systems

CROSS COUNTRY PIPELINE Vertical Down Welding Joint Preparation The joint preparation usually used for cross country pipeline is from API 1104 code. As shown in the figure below, the normal situation is a “penny land, penny gap”, meaning that the land (root face) on the pipe should be ground to approximately the thickness of a penny [1/16 ...

  Pipeline

COMMON FAILURE MODES IN PRESSURISED PIPELINE …

COMMON FAILURE MODES IN PRESSURISED PIPELINE SYSTEMS The following tables summarise the most common types of field failure modes in water supply mains and pressure sewers and associated fittings and appurtenances. The table has been developed specifically for Australian pipes, environments and operating conditions and is designed

  Pipeline

DIESEL TRANSPORT, STORAGE AND REFUELLING …

♦ The pipeline between the surface batch tank and the underground storage tank should contain no other valves or devices that may create a blockage or restriction. This will ensure that there is no risk of the formation and auto-ignition of air fuel vapour and that the pipeline contains diesel fuel only while the

  Transport, Storage, Diesel, Pipeline, Refuelling, Diesel transport, Storage and refuelling

SOUTH CAROLINA RECIPROCITY/WAIVER AGREEMENTS

Page 1 of 3 Rev. 02/2019 All . eligible applicants. that have passed a technical exam(s) listed on page 2 must do the following: 1. Pass the SC Business Management and Law for Commercial Contractors exam through PSI (call

1.4 Natural Gas Combustion - US EPA

1.4.3 Emissions3-4 The emissions from natural gas-fired boilers and furnaces include nitrogen oxides (NOx), carbon monoxide (CO), and carbon dioxide (CO2), methane (CH4), nitrous oxide (N2O), volatile organic compounds (VOCs), trace amounts of sulfur dioxide (SO2), and particulate matter (PM). Nitrogen Oxides -

  Natural, Natural gas