Ttl Serial
Found 6 free book(s)Arduino Nano - Farnell
www.farnell.comSerial: 0 (RX) and 1 (TX). Used to receive (RX) and transmit (TX) TTL serial data. These pins are connected to the corresponding pins of the FTDI USB-to-TTL Serial chip. External Interrupts: 2 and 3. These pins can be configured to trigger an interrupt on a low value, a rising or falling edge, or a change in value.
2-Wire Serial EEPROM AT24C32 AT24C64 - Microchip …
ww1.microchip.com1 Features • Low-Voltage and Standard-Voltage Operation – 2.7 (V CC = 2.7V to 5.5V) – 1.8 (V CC = 1.8V to 5.5V) • Low-Power Devices (ISB = 2 µA at 5.5V) Available • Internally Organized 4096 x 8, 8192 x 8 • 2-Wire Serial Interface • Schmitt Trigger, Filtered Inputs for Noise Suppression • Bidirectional Data Transfer Protocol • 100 kHz (1.8V, 2.5V, 2.7V) and 400 kHz …
Platform Cable USB II - Xilinx
www.xilinx.comThe slave-serial mode and direct SPI are only supported in limited versions of the ISE iMPACT tool. In addition, Platform Cable USB II is op timized for use with the Xilin x Embedded Development Kit, ChipScope Pro Analyzer, and System Generator for DSP. When used with these software tools, the cable provides a connection to embedded target
Low-density access line, ARM®-based 32 bit MCU with 16 or ...
www.st.com– Serial wire debug (SWD) and JTAG interfaces • DMA – 7-channel DMA controller – Peripherals supported: timers, ADC, SPIs, I2Cs and USARTs • 1 × 12-bit, 1 µs A/D converter (up to 16 channels) – Conversion range: 0 to 3.6 V – Temperature sensor • Up to 51 fast I/O ports – 26/37/51 I/Os, all mappable on 16 external
Cisco NetFlow Configuration
www.cisco.comMod Submodule Model Serial No. Hw Status 1. Netflow Services Card WS-F4531 JAB062209CG 0.2 Ok 2. Netflow Services Card WS-F4531 JAB062209CG 0.2 Ok Best Practice / Highlights Cisco IOS NetFlow Configuration Guide Cisco 6500 & 7600 NetFlow Configuration Guide Catalyst 4500 NetFlow Configuration Guide Cisco 3850 NetFlow Configuration Guide Cisco ...
Medium-density access line, ARM® -based 32-bit MCU with …
www.st.com– Serial wire debug (SWD) and JTAG interfaces DMA – 7-channel DMA controller – Peripherals supported: timers, ADC, SPIs, I2Cs and USARTs 1 × 12-bit, 1 µs A/D converter (up to 16 channels) – Conversion range: 0 to 3.6 V – Temperature sensor Up to 80 fast I/O ports – 26/37/51/80 I/Os, all mappable on 16