Winder Tension
Found 4 free book(s)M1500 / M1505 Instruction Manual M1600 / M1605
res.cloudinary.com- Wind the thread clockwise around bobbin winder tension discs. (3) - Thread bobbin as illustrated and place on spindle. (4) - Push bobbin spindle to right. (5) - Hold thread end. (6) - Step on foot control pedal. (7) - Release the pedal after a few turns. Release the thread and cut as close as possible to the spool. Press the pedal again.
INSTRUCTION MANUAL - Janome
www.janome.comq Bobbin winder stopper w Bobbin winder spindle e Hole for additional spool pin r Spool holder t Spool pin y Bobbin winder thread guide u Thread take-up lever i Face plate o Thread cutter!0 Needle plate!1 Extension table (Accessory storage)!2 Hook cover plate!3 Hook cover plate release button!4 Thread tension dial!5 Reverse stitch lever
Singer Electric Sewing Machine 201-2 - ISMACS
ismacs.nettween nthe tension discs (2) on the bed of -the machine, then pass the thread up and through the hole (3) in the left side of the bobbin, from the inside. Press down on the bobbin and the bob- bin winder latch (A, Fig. 5) will drop down and hold the bobbin winder pulley against the hub of the balance Wheel. Then press the knee lever
Singer Electric Sewing Machine 201-2
ismacs.nettween nthe tension discs (2) on the bed of -the machine, then pass the thread up and through the hole (3) in the left side of the bobbin, from the inside. Press down on the bobbin and the bob- bin winder latch (A, Fig. 5) will drop down and hold the bobbin winder pulley against the hub of the balance Wheel. Then press the knee lever