Search results with tag "Uart interface"
FT232R USB UART I.C. - SparkFun Electronics
www.sparkfun.comThe FT232R is the latest device to be added to FTDI’s range of USB UART interface Integrated Circuit Devices. The FT232R is a USB to serial UART interface with optional clock generator output, and the new FTDIChip-ID™ security dongle feature. In addition, asynchronous and synchronous bit bang interface modes are available. USB to serial
Future Technology Devices International Ltd
www.ftdichip.comFTDI FT232B style, asynchronous serial UART interface option with full hardware handshaking and modem interface signals. Fully assisted hardware or X -On / X -Off software handshaking. UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity. Auto -transmit enable control for RS485 serial
Future Technology Devices International Ltd
www.ftdichip.comAsynchronous serial UART interface option with full hardware handshaking and modem interface signals. Fully assisted hardware or X-On / X-Off software handshaking. UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity. Auto transmit enable control for RS485 serial the TXDEN pin.
STM32™ and STM8™ Flash loader demonstrator
www.st.comThis step consists in selecting the UART connection interface and its related settings. Set the connection settings (port name, baud rate and timeout, etc.) as shown in Figure 5. For an optimum configuration for the UART interface, set “Baud Rate” to 115200 bits per second and “Timeout(s)” to 5 seconds.
UM2448 User manual - STMicroelectronics
www.st.com– 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs (extended down to 1.65 V with the B-STLINK-VOLT or B-STLINK-ISOL board) – VCP frequency up to 16 MHz – Available on STDC14 debug connector (not available on MIPI10) • Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features:
CP2104 - Silicon Labs
www.silabs.comThe CP2104 UART interface implements all RS-232/RS-485 signals, including control and handshaking signals, so existing system firmware does not need to be modified. The device also features up to four GPIO signals that can be user-defined for status and control information. Support for I/O interface voltages down to 1.8V is provided via a VIO ...
CP2103 - Silicon Labs
www.silabs.comThe CP2103 UART interface implements all RS-232/RS-485 signals, including control and handshaking signals; so, exis ting system firmware does not need to be modified. The device also features up to four GPIO signals that can be user-defined for status and control information. Support for I/O interface voltages down to 1.8 V is provided via a ...