Search results with tag "Width across flats"
IS 2027 (1992): Spanners and sockets - Widths across flats
law.resource.orgin IS0 272-1979 ‘Fasteners-Hexagon products-Width across flats’, issued by the International Organization for Standardization (ISO) and taking assistance from IS0 691-1975 ‘Spanner gaps and sockets-Metric series-Tolerances for general use, …
WRENCH OPENINGS FOR SQUARE NUTS AND ... - Sales …
catalogue.salessystemsltd.commost cases) width across flats dimension of the respective nut. For specific requirements applicable to wrenches, refer to the appropriate American National Standard, ANSI B107 document, which covers the particular wrench type. 2. Allowance (minimum clearance) between maximum width across flats of the nut and jaws of wrench equals (0.005W + 0.001).
IS 1367-2 (2002): Technical Supply Conditions for Threaded ...
law.resource.org1.1.4.3 Bearing face diameter and d~ ~i” = S~in – IT16 for width across flats <21 mm For product leight of washer-faced portion d~ ~in = 0,95 Sminfor width across flats >21 mm grade C a washer face is @ x d not mandatory. w max = sactual Thread c diameter min. max.
Fastener and Hardware Abbreviations
www.aallamericanfasteners.comUNJ Unified National Thread with Large Radius Rood (special fatigue resistant thread) UNR Unified National Thread with Radius Root USS United States Standard when used with washers - large OD, when used with screws or nuts = coarse thread UTS Ultimate Tensile Strength WA Width Across orners WAF Width Across Flats
COMMAN ABBREVIATIONS USED WITH FASTENERS
pvfastener.comUNJ - Unified National Thread with Large Radius Root (special fatigue resistant thread) UNR - Unified National Thread with radius root USS - United States Standard used with washers it is for large OD used with screws or nuts it means coarse thread UTS - Ultimate Tensile Strength WAC - Width Across Corners WAF - Width Across Flats
DIN 6921 - New Fastener LLC
www.newfastener.com2) In a deviation from DIN ISO 4759 Part 1, May 1980 edition, subclause 11.3, the parallelism of the flats may lie within the tolerance field h 13 for the width across flats. 5 Designation Designation of a standard design hexagon flange bolt with thread size d = M 10, length I = 60 mm and property class 10.9:
2-1 - Tohnichi
www.tohnichi.comB: Hexagon width across flats [mm] dH: Bearing surface inside diameter [mm] b. Round shape bearing surface (second, third type nut) dn = ・ D: Bearing surface outside diameter [mm] dH: Bearing surface inside diameter [mm] 0.608B3 − 0.524dH3 0.866B2 − 0.785dH2 2 3 D3 − dH3 D2 − dH2 T = K.d.Ff or Ff =