Search results with tag "Fet input"
OPA657 1.6-GHz, Low-Noise, FET-Input Operational …
www.ti.comOPA657 ±5 1600 700 4.8 Gain of +7 stable FET Input OPA656 ±5 230 290 7 Unity-Gain Stable FET-Input OPA659 ±6 350 2550 8.9 Unity-Gain Stable FET-Input LMH6629 5 4000 1600 0.69 Gain of +10 stable Bipolar Input THS4631 ±15 210 1000 7 Unity-Gain Stable FET-Input Programmable Gain (5 kΩ/ 20 kΩ) OPA857 5 4750 220 — Transimpedance Amplifier
Low Power, Low Noise Precision FET Op Amp Data Sheet …
www.analog.comThe AD795 is a low noise, precision, FET input operational amplifier. It offers both the low voltage noise and low offset drift of a bipolar input op amp and the very low bias current of a FET-input device. The 1014 Ω common-mode impedance insures that input bias current is essentially independent of common-mode voltage and supply voltage ...
Single-Supply, Rail-to-Rail, Low Power, FET Input Op Amp …
www.analog.comThe AD820 is a precision, low power FET input op amp that can operate from a single supply of 5 V to 36 V, or dual supplies of ±2.5 V to ±18 V. It has true single-supply capability, with an input voltage range extending below the negative rail, allowing the AD820 to accommodate input signals below ground in the single-supply mode.
Single-Supply, Rail-to-Rail Low Power FET-Input Op Amp ...
www.analog.comis a dual precision, low power FET input op amp that can operate from a single supply of 5V to 30 V or from dual supplies of ± 2.5 V to ±15 V. It has true sin gle-supply capability with an input voltage range extending below the negative rail, allowing the AD822 to accommodate input signals below ground while in the single-supply mode.
EDCh 2 other linear circuits - Analog Devices
www.analog.com(A) HOS-100 Bipolar, (B) LH0033 FET Input If high input impedance is required, a dual FET can be used as an input stage ahead of a complementary emitter follower, as shown in Figure 2.1B. This form of the buffer circuit was implemented by both National Semiconductor Corporation as the LH0033, and by Analog Devices as the ADLH0033.
TL084, TL084CN GENERAL PURPOSE QUAD JFET OP …
ampslab.com1/12 wide common-mode (up to vcc +) and differential voltage range low input bias and offset current output short-circuit protection high input impedance j–fet input
Wide Supply Dual, 17 MHz, Rail-to-Rail FET Input …
www.analog.comWide Supply Dual, 17 MHz, Rail-to-Rail FET Input Amplifier Data Sheet AD823A Rev. B Information furnished by Analog Devices is believed to be accurate and reliable.
Single-Supply, Rail-to-Rail, Low Power, FET Input Op Amp …
www.analog.comSingle-Supply, Rail-to-Rail, Low Power, FET Input Op Amp AD820 Rev. H Information furnished by Analog Devices is believed to be accurate and reliable.
LTC6268/LTC6269 - 500MHz Ultra-Low Bias Current …
www.analog.comLTC 6268LTC 6269 1 62689 For more information www.linear.com/LTC6268 TYPICAL APPLICATION FEATURES DESCRIPTION 500MHz Ultra-Low Bias Current FET Input Op …
FET-Input, Low Distortion Operational Amplifier …
www.ti.comfeatures low distortion: 0.0003% at 1khz low noise: 10nv/√hz high slew rate: 25v/µs wide gain-bandwidth: 20mhz unity-gain stable