Search results with tag "Policy based routing"
Configuring Policy-Based Routing - Cisco
www.cisco.comChapter 26 Configuring Policy-Based Routing Policy-Based Routing Configuration Task List Policy-Based Routing Configuration Task List To configure PBR, perform the tasks described in the following sections. The task in the first section is required; the tasks in the remaining sections are optional. See the end of this chapter for the section ...
Aruba 5400R ZL2 Switch Series - Data sheet
www.arubanetworks.com• Policy-based routing uses a classifier to select traffic that can be forwarded based on policy set by the network administrator (requires v2 or higher modules) • Border Gateway Protocol (BGP) provides IPv4 Border Gateway Protocol routing, which is scalable, robust, and flexible Security.
DELL EMC NETWORKING S3048-ON
i.dell.comcomplement of standards-based IPv4 and IPv6 features, includ-ing OSPF, BGP and PBR (Policy Based Routing) support • Four SFP+ 10GbE ports for maximum flexibility and investment protection • I/O panel to PSU airflow or PSU to I/O panel airflow • Redundant, hot-swappable power supplies and fans
Configuring IPsec VPN Fragmentation and MTU
www.cisco.compolicy-based routing (PBR) or the crypto df-bit clear command. † If GRE encapsulation is not taken over by the VSPA, and if the packets exceed the IP MTU of the GRE tunnel interface, the route processor will fragment and encapsulate the packets. Note If the supervisor engine perfor ms GRE encapsulation, the encapsul ated packets will have the DF
Configuring Route Maps and Policy-Based Routing
ptgmedia.pearsoncmg.comRoute Map Overview 149 The next example is the syntax of an actual route map. Example 2-3 demonstrates how a route map can be applied during redistribution.
Policy-Based Routing (PBR) - Cisco
www.cisco.comwhich provides more control over routing than a routing protocol does and avoids the need to configure interface-level traffic classification. PBR can route unicast traffic along a different path than a routing ... Sets an access list to be matched. Step 8 end Example: Router(config-route-map)# end Exits route-map configuration mode and returns to