Example: biology
Search results with tag "Thread and connector identification"
Thread and Connector Identification - Gerrard Hydraulics
www.gerrardhydraulics.com.auThread and Connector Identification Thread size refers to the nominal bore of the pipe. Subtract approximately 1/4”(6 mm) from thread meas ure ment for nominal pipe size. Pitch is Threads Per Inch (TPI). NPT & NPS THREADS NPT is NATIONAL PIPE TAPER (AMERICAN) Thread form per ANSI/ASME B1.20.1
Thread and Connector Identification - Gerrard Hydraulics
www.gerrardhydraulics.com.auJIC 37° FLARE & UNO (O RING BOSS) THREADS JIC is JOINT INDUSTRIES COUNCIL SAE J514, ISO 8434-2 UN is UNIFIED NATIONAL SAE J1926, ISO 11926-2 JIC & UNO (O Ring Boss) thread forms are the same (ASME B1.1). Method of sealing differs. JIC male has 37° flare which seals against 37° seat in female. UNO (O Ring Boss) seals with O Ring compressed