Search results with tag "Configuring static routes"
Basic Router Configuration - Cisco
www.cisco.com† Viewing the Default Configuration † Information Needed for Configuration † Configuring Basic Parameters † Configuring Static Routes † Configuring Dynamic Routes † Configuring Enhanced IGRP Each section includes a configuration …
ccnp routing studyguide - Router Alley
routeralley.comSection 6 Static vs. Dynamic Routing Section 7 Configuring Static Routes Section 8 Default Routing Part III – Dynamic Routing Protocols Section 9 RIP v1 & v2 Section 10 IGRP Section 11 EIGRP Section 12 OSPF Section 13 IS-IS Section 14 BGP Part IV– Advanced Routing Functions
Basic Router Configuration - Cisco
www.cisco.com† Configuring Static Routes, page 23 ... The loopback interface acts as a placeholder for the static IP address and provides default routing information. For complete information on the loopback commands, see the Cisco IOS Release configuration guide documentation set.
configuring static routes - Router Alley
routeralley.com- Configuring Static Routes - Configuring Static Routes The basic syntax for a static route is as follows: Router(config)# ip route [destination_network] [subnet_mask] [next-hop] Consider the following example: RouterA will have the 172.16.0.0/16 and 172.17.0.0/16 networks in its routing table as directly-connected routes. To add a static route ...
configuring static routes - Router Alley
www.routeralley.comConfiguring Static Routes v1.10 – Aaron Balchunas * * * All original material copyright © 2007 by Aaron Balchunas ( aaron@routeralley.com ), unless otherwise noted ...