Search results with tag "Spindle nuts"
FASTENER IDENTIFICATION AND TORQUE DATA
www.inetefb.comThe amount of torque required to run the nut down (friction drag torque) should be measured and added to the amount of torque specified for the fastener. ... spindle nut 32-20 (Refer to 32-20) (Refer to 32-20) (Refer to 32-20) (Refer to 32-20) ... Torque Specifications for High Strength Steel Tension Nuts and Bolts with FINE Threads Item Thread ...
MERITOR WHEEL BEARING ADJUSTMENT SYSTEM FOR THE …
meritorcya.comOptimal Preload with the Doctor Preload Tool. Doctor Preload, when used in conjunction with Temper-Loc spindle nuts, is the ideal wheel-end
Spindle Nuts - Conmet
www.conmet.comDesigned specifically for ConMet® Hub Assemblies, our new spindle nuts ease hub installation, provide infinite adjustability and improve clamp load retention. ConMet Spindle Nuts: Locked and Loaded with Options. Taking spindle nuts to the next level.
Manual Wheel Bearing Adjustment Procedures
www.timken.comFor one-piece spindle nut systems, torque the nut to a minimum of 300 ft-lbs. Do not back off the spindle nut. Engage any locking device that is part of the spindle nut system. If the locking device cannot be engaged when the nut is at 300 ft-lbs, advance the nut until engagement takes place and the nut is locked.
SKF Torque specification guide - PHP Hosting
caissiedrive.netIt will also leave your spindle nut under or over torque resulting in hub assembly failure. Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life. Under ...
Catalog 457377 2014
caissiedrive.netUse a qualified, calibrated torque wrench. Do not use an impact gun to install the axle nut. The impact gun will damage the axle nut. It will also leave your spindle nut under or over torque resulting in hub assembly failure. To ensure that you have the correct torque for the application refer to this guide or contact the vehicle manufactures ...