Search results with tag "Laser beam"
General ULS Troubleshooting Guide - LST Group
www.lstgroup.com.au* Adjust ambient temperature to within specifications * Check and/or adjust laser beam alignment * Check and/or adjust cone so that laser beam is in center * Replace laser tube Engraving is sharp, clear and at a good depth on one side of the table and fuzzy and shallow on the opposite side of the table * Out of focus * Dirty laser system
LECTURE NOTES ON
www.cet.edu.inLASER BEAM MACHINING (LBM): Introduction, equipment of LBM mechanism of metal removal, LBM parameters, Process characteristics, Applications, Advantages & limitations. ELECTRON BEAM MACHINING (EBM): Principles, equipment, operations, applications, advantages and limitation of EBM. Module III (11 hours)
Stainless Steel 1.4404 - ThyssenKrupp
ucpcdn.thyssenkrupp.comTemperature °C Type of Cooling Temperature °C 2) 3) 4) Type of Cooling Microstructure 1150 to 850 Air 1030 to 1110 Water, air Austenite with a low content of ferrite ... 1.4404 is also suitable for laser beam fusion cutting with nitrogen or flame cutting with oxygen. The cut edges only have small heat affected zones