Search results with tag "Coax cable"
Review: The MFJ-994BRT and MFJ-998RT Remote ... - AD5X
www.ad5x.comThe reason is that a remote antenna tuner is an efficient way to match an antenna that has a high SWR and is fed through a relatively long length of coax cable. This is because SWR-related coax cable losses can be high when the antenna SWR is high even if an in-shack tuner provides a 1:1 SWR for your equipment. You can easily demonstrate this
Spectrum TV Self-Install Instructions
d15yx0mnc9teae.cloudfront.netCoax Cable. Note: Not all cables will be . used during the installation. For your High . Definition TV. With your TV manufacturer’s remote. control, change the “input/source” setting on the TV to the proper connection type (HDMI or Component). *If you do not have an HDMI input available.
WINEGARD Gateway
d38mfwkkxtsm2m.cloudfront.netWARNING: There is a coax cable connected to the over-the-air antenna under the dome. Gently remove the dome and lay on its side next to the base to avoid damaging the antenna, coax, or other antennas within the dome. Step 1 – Remove the four screws on the outside of the Air 360+ dome and gently remove the dome.
Coaxial Cable Delay - VE2AZX
www.ve2azx.netfrequencies well below fδ the two inductances add up, thus increasing the series inductance by 20%. From equation 1 and 2, this increase will cause an increase in the delay and line impedance by 10%. Figure 6 shows the results of my delay measurements on a length of 81 feet of RG-58 type coax cable.