Transcription of 3.5 Settings - Fujitsu Global
{{id}} {{{paragraph}}}
Example: dental hygienist
3.5 Settings - Fujitsu Global
Installation Requirements Settings Default jumper Settings Figure shows the types of switches and their Settings when the drive was shipped. Figure Setting terminal (CNH2). Setting terminal (1) SCSI ID. Table shows the SCSI ID Settings of the drive. Table SCSI ID setting (CNH2). SCSI ID Pin 5-6 Pin 3-4 Pin 1-2. 0 Open Open Open 1 Open Open Short 2 Open Short Open 3 Open Short Short 4 Short Open Open 5 Short Open Short 6 *1 Short Short Open 7 Short Short Short *1 Factory setting 3-18 C156-E224-01EN. Settings 1) Each SCSI device connected to the same SCSI bus must have a unique SCSI ID. 2) If contention occurs in the ARBITRATION phase, the priority of the SCSI use authority depends on SCSI IDs as follows: 7>6>5>4>3>2>1>0. (2) SCSI terminating resistor mode Enabling or disabling the SCSI terminating resistor, module on the PCA can be set. When the drive positions at other than the end of the SCSI bus, the SCSI.
3.5 Settings C156-E224-01EN 3-19 1) Each SCSI device connected to the same SCSI bus must have a unique SCSI ID. 2) If contention occurs in …
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: