Transcription of AN149 Modeling and Loop Compensation Design …
{{id}} {{{paragraph}}}
Example: confidence
AN149 Modeling and Loop Compensation Design …
Application Note 149AN149-1an149faJanuary 2015 IdentIfyIng the ProblemA well-designed switching mode power supply (SMPS) must be quiet, both electrically and acoustically. An under-compensated system may result in unstable operations. Typical symptoms of an unstable power supply include: audible noise from the magnetic components or ceramic capacitors, jittering in the switching waveforms, oscillation of output voltage, overheating of power FETs and so on. However, there are many reasons that can cause undesir-able oscillation other than loop stability. Unfortunately, they all look the same on the oscilloscope to the inexperienced supply designer. Even for experienced engineers, some-times identifying the reason that causes the instability can be difficult. Figure 1 shows typical output and switching node waveforms of an unstable buck supply.
A N 149 AN149-2 an149fa Forswitchingmodepowerconverters, suchas an LTC®3851 or LTC3833 current-mode buck supply shown in Figure 2, a fast way to determine whether ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Channel Reduced Qg, Fast Switching MOSFET, Fast Switching, 1N4148 www.vishay.com, The High-Frequency Switching Noise, THE HIGH FREQUENCY SWITCHING NOISE, Switching, Input Filter Design for Switching Power Supplies, Cisco CCNA Routing and Switching, Three-way, snap-acting switching, AND9093 - Using MOSFETs in Load Switch, 2- directional valves with