Transcription of ANNEX SPECIFICATION FOR STRUCTURES TO BE …
{{id}} {{{paragraph}}}
ANNEX . SPECIFICATION FOR STRUCTURES TO BE BUILT IN DISASTER AREAS. CHAPTER I - GENERAL PRINCIPLES. SCOPE. - Requirements of this SPECIFICATION shall be applicable to newly constructed buildings as well as to existing buildings. - Provisions to be applied for the prevailing buildings of which the intended use and / or carrier system shall be changed, the performance shall be evaluated before or after the earthquake and buildings to be strengthened were given in Section - 7. - Requirements of this SPECIFICATION shall be applicable to reinforced concrete (cast-in-situ and pre - stressed or non - pre - stressed prefabricated) buildings, structural steel buildings and building-like STRUCTURES , and timber, masonry and adobe buildings. - Minimum conditions and rules to be implied to wooden buildings and such kind of buildings shall be determined by the Ministry of Public Works and Settlement until the provisions of relevant SPECIFICATION shall be put into effect and projects of them shall be arranged according to those basis.
2 1.2.2 - The design earthquake considered in this Specification, corresponds to high- intensity earthquake defined in 1.2.1 above.For buildings with Building Importance Factor
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
100G PSM4 Specification, Single Mode, BendBright XS Single Mode Optical, BendBrightXS Single Mode Optical, Manual, Technical, IVMS-4200 Client Software Technical Specification, IVMS-4200 Client Software, SPECIFICATION, Mode, Single, 120V Wall Switch Sensor Ground Required, Maestro 0-10V dimmer sensor, Lutron Electronics, Technical Specification