Transcription of Ballast Installation Requirements - Lutron Electronics
{{id}} {{{paragraph}}}
Example: bachelor of science
Ballast Installation Requirements - Lutron Electronics
Ballast Installation RequirementsEcoSystemR / Hi-lumeR 3D / H-SeriesRSolid copper 22 AWG ( mm2) wire5/16 in(8 mm)Socket Wiring: Use 18 AWG ( mm2) solid copper or tinned stranded wire. Referto Ballast label and socket manufacturer for proper strip proper wiring:Follow wiring schematic on Lead Length Requirements :T4 Compact T5 Twin Tube7 ft ( m)3 ft ( m)Lamp Type Max. Length of Socket Leads ( Ballast to socket) T5 Linear T8 Linear T8 U-BendMake sure yellows are wired in parallel, not in wire strip lengths:For power, output, and digital terminals (E1, E2).Solid copper 18 AWG ( mm2) wire5/16 in(8 mm)CorrectIncorrectFor control and sensor to three lampsH-SeriesEcoSystemR & Hi-lumeR 3 DLamp WiringNote:Yellows wiredin parallelSocket CAT III T5 Socket CAT III T8 CorrectCorrectBallast MountingLamp Socket Wiring TesterCorrectIncorrectMount Ballast flush against fixture to provide best heat transfer.
Ballast Installation Requirements EcoSystemR / Hi-lumeR 3D / H-Series R Solid copper 22 AWG (0.25 mm2) wire 5/16 in (8 mm) Socket Wiring: Use 18 AWG (0.75 …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: