Transcription of Batch Control Part 1: Models and Terminology
{{id}} {{{paragraph}}}
Example: confidence
Batch Control Part 1: Models and Terminology
Batch ControlPart 1: Models and TerminologyApproved 23 October 1995 ANSI/ISA 1995 FormerlyANSI/ISA 1995 AMERICAN NATIONAL STANDARDISA The Instrumentation,Systems, andAutomation Society TMCopyright 1995 by the Instrument Society of America. All rights reserved. Printed in the UnitedStates of America. No part of this publication may be reproduced, stored in a retrieval system, ortransmitted in any form or by any means (electronic, mechanical, photocopying, recording, orotherwise), without the prior written permission of the Alexander Box 12277 Research Triangle Park, North Carolina 27709 , Batch Control , part 1: Models and TerminologyISBN: 1-55617-562-0 PrefaceThis preface as well as all footnotes and annexes are included for informational purposes and are not part of standard has been prepared as part of the service of the ISA, the international society for measurement and Control , toward a goal of uniformity in the field of instrumentation.
metric units in all new and revised standards to the greatest extent possible. The Metric Practice Guide, which has been published by the Institute of Electrical and Electronics Engineers as ANSI/IEEE Std. 268-1992, and future revisions, will be the reference guide for definitions, symbols, abbreviations, and conversion factors.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: