Transcription of Batch Plant Calibration - ctqpflorida.com
{{id}} {{{paragraph}}}
Asphalt Plant Level II - July 2005 1 of 11. appendix 3b Slide 1. Construction Training Qualification Program Asphalt Plant Level II. appendix 3b Batch plants Hot Bin Calibration Practice Problems This is the technique used to Slide 2. Calibration of Hot Bins establish hot bin pulls , or the individual Batch plants bin weights, from a batching Plant . (Establishing Hot Bin Percentages and Weights for Production Requirements). July 2005 appendix 3b - 2. These are the typical procedures Slide 3. one goes through. Batch Plant Calibration 1) Start the Plant - run the cold feed, the dryer, and the screens Start the Plant - run the cold feed, the dryer, and the screens 2) After stabilization - sample the After stabilization - sample the material from material from each hot bin each hot bin 3) Washed gradations are preferred - but Washed gradation is preferred - but dry dry gradation is acceptable.
Asphalt Plant Level II - July 2005 3 of 11 Appendix 3b Slide 7 July 2005 Appendix 3b - 7 Blending of Aggregates Sieve BIN 1 BIN 2 BIN 3 BIN 4 Blend JMF
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}