Transcription of Brueninghaus Hydromatik Rexroth A10VO & A10VSO pump
{{id}} {{{paragraph}}}
Brueninghaus Hydromatik Rexroth A10VO & A10 VSO pump Open circuit Size: Series: 31, 52, 53 Nominal pressure 280 bar. Peak pressure 350 bar Features Axial piston pump A10SO, variable, in swash plate design for hydrostatic transmissions in open loop circuit Flow is proportional to drive speed and displacement. By adjusting the swash plate angle it is possible to infinitely vary the flow Mounting flange acc. to SAE J744 Flanged ports acc. to SAE J518 2 case drain ports Good suction characteristics Permissible working pressure 280 bar Low noise level Long service life Axial and radial loading of drive shaft possible High power to weight ratio Wide range of controls Short response times Interchangeable with original Rexroth pump of the same model A10V SO 100DR /31 R- P P A 12 N00 Port type.
This will supply the control piston directly with control oil; a minimum pressure of 50 bars is required. DR - Pressure control The pressure control serves to maintain a constant pressure in the hydraulic system, within the control range of the pump. The pump therefore supplies only the amount of hydraulic fluid required by the actuators.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}