Transcription of Capacitive Touch Using Only an ADC (CVD) App. Note
{{id}} {{{paragraph}}}
AN1298. Capacitive Touch Using only an ADC ( CVD ). Sensing Steps Authors: Thomas Perme Dieter Peter To perform the sensing, do the following: Microchip Technology Inc. 1. Drive secondary channel to VDD as digital output. INTRODUCTION 2. Point ADC to the secondary VDD pin (charges CHOLD to VDD). This application note describes a new hardware 3. Ground sensor line. sensing method called Capacitive Voltage Divider 4. Turn sensor line as input (TRISx = 1). (CVD) which uses no external components. It requires 5. Point ADC to sensor channel (voltage divider only the ADC to perform Capacitive Touch sensing. The from sensor to CHOLD). principle is simple, and can be applied to nearly any Microchip PIC device with an ADC.
© 2009 Microchip Technology Inc. DS01298A-page 1 AN1298 INTRODUCTION This application note describes a new hardware sensing method …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}