Transcription of CHAPTER 10 TRAPS, INTERCEPTORS AND SEPARATORS
{{id}} {{{paragraph}}}
Example: confidence
CHAPTER 10 TRAPS, INTERCEPTORS AND SEPARATORS
CHAPTER 10 TRAPS, INTERCEPTORS AND SEPARATORSSECTION CHAPTER shall govern the material andinstallation of traps, INTERCEPTORS and 1002 TRAP Fixture plumbing fixture shall be sepa-rately trapped by a liquid-seal trap, except as otherwise permit-ted by this code. The vertical distance from the fixture outlet tothe trap weir shall not exceed 24 inches (610 mm), and the hori-zontal distance shall not exceed 30 inches (610 mm) measuredfrom the centerline of the fixture outlet to the centerline of theinlet of the trap. The height of a clothes washer standpipe abovea trap shall conform to Section A fixture shall not bedouble :1. This section shall not apply to fixtures with A combination plumbing fixture is permitted to beinstalled on one trap, provided that one compartmentis not more than 6 inches (152 mm) deeper than theother compartment and the waste outlets are not morethan 30 inches (762 mm) A grease interceptor intended to serve as a fixture trapin accordance with the manufacturer s installationinstructions shall be permitted to serve as the trap for asingle fixture or a combination sink of not more thanthree compartments where the vertical distance fromthe fixture outlet to the inlet of the interceptor does notexceed 30 inches (762 mm) and thedev
CHAPTER 10 TRAPS, INTERCEPTORS AND SEPARATORS SECTION 1001 GENERAL 1001.1 Scope. This chapter shall govern the material and installation of traps, interceptors and separators.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: