Transcription of CHAPTER 20 ALUMINUM - eCodes
{{id}} {{{paragraph}}}
CHAPTER 20. ALUMINUM . SECTION 2001 Loads. Structural members supporting screened GENERAL enclosures shall be designed for wind in both of two orthogonal Scope. Provisions of this CHAPTER shall govern the qual- directions using the pressures given in Table Each pri- ity, design , fabrication and erection of ALUMINUM alloys used in mary member shall also be designed for a 300 pound ( kN). building construction. load applied vertically downward along any 1 foot (305 mm) of any member, not occurring simultaneously with wind load. Exception: Buildings and structures located within the high-velocity hurricane zone shall comply with the provi- Exception: In addition to wind pressures, purlins shall also sions of Section 2003. be designed for a 200 pound ( kN) load applied verti- cally downward along any 1 foot (305 mm) of any member, not occurring simultaneously with wind load.
CHAPTER 20 ALUMINUM SECTION 2001 GENERAL 2001.1 Scope. Provisionsofthischaptershallgovernthequal-ity,design,fabricationanderectionofaluminumalloysusedin
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Design of aluminium structures Part, Design of aluminium structures, Eurocode 9 — Design of aluminium structures, Structures, Of Aluminium, Design of aluminium, Aluminium structures, Design, Fire exposed aluminium structures, Aluminium, DESIGN OF ALUMINIUM STRUCTURES FOR THE, DESIGN OF ALUMINUM ALLOY, Aluminum Structures Structural Engineering, Connections in fire exposed aluminium structures