Transcription of Chapter 6. Compression Reinforcement - Flexural Members
{{id}} {{{paragraph}}}
Example: biology
Chapter 6. Compression Reinforcement - Flexural Members
Chapter 6. Compression Reinforcement - Flexural Members If a beam cross section is limited because of architectural or other considerations, it may hap- pen that the concrete cannot develop the Compression force required to resist the give bending mo- ment. In this case, reinforcing is added in the Compression zone, resulting in a so-called doubly rein- forced beam, , one with Compression as well as tension Reinforcement . Compression reinforced is also used to improve serviceability, improve long term deflections, and to provide support for stir- rups throughout the beam. Reading Assignment: Text Section ; ACI 318, Sections: , , and Strength Calculations u = c . Cs A's s . a b = 1c b Cc d' cb h d A bs d-c b h-c b T bs b s = y strains stresses forces From geometry we can find the strain in Compression steel at failure as: s = c.
6.4. Compression Steel below Yield Stress (strain compatibility check). Whether or not the compression steel will have yieldedat failure can be determined as fol-lows: From geometry: Á u Á′ s = c c −d ′ if compression steel yield Á′ s = Á y then: Á u Á y = c c −d ′ → c = Á u Á u −Á y d ′ Equilibrium for case II: (Alim ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: