Transcription of Chapter 9 Lab A: Configuring ASA Basic Settings and ...
{{id}} {{{paragraph}}}
Example: marketing
Chapter 9 Lab A: Configuring ASA Basic Settings and ...
2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 26 CCNA Security Chapter 9 Lab A: Configuring ASA Basic Settings and firewall Using CLI This lab has been updated for use on NETLAB+ Topology Note: ISR G2 devices use GigabitEthernet interfaces instead of FastEthernet interfaces. CCNA Security Chapter 9 Lab 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 26 IP Addressing Table Device Interface IP Address Subnet Mask Default Gateway Switch Port R1 G0/0 N/A ASA G1/1 S0/0/0 (DCE) N/A N/A R2 S0/0/0 N/A N/A S0/0/1 (DCE) N/A N/A R3 G0/1 N/A S3 F0/5 S0/0/1 N/A N/A ASA G1/2 NA S2 F0/24 ASA G1/1 NA R1 G0/0 ASA G1/3 NA S1 F0/24 PC-A NIC S1 F0/6 PC-B NIC S2 F0/18 PC-C NIC S3 F0/18 Objectives Part 1: Basic Router/Switch/PC Configuration Configure hostnames and interface IP addresses for routers, switches, and PCs.
In Parts 2 through 4 you will configure basic ASA settings and the firewall between the inside and outside networks. In part 5 you will configure the ASA for additional services, such as DHCP, AAA, and SSH. In Part 6, you will configure a DMZ on the ASA and provide access to …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: