Transcription of ClearConnect LED Important Notes: Raise All On ...
{{id}} {{{paragraph}}}
Example: bachelor of science
ClearConnect LED Important Notes: Raise All On ...
Permanently install Wireless Transmitters 4 Note: Please consult individual component installation guides for stLinkWhen installing a PowPakTM Dimming Module, use supplied conduit nut and wire the module as , wire and install EcoSystem devices and lighting fixtures1 Connect power wiring (hot, neutral, ground) to each fixture. Connect bus cable (E1 and E2) to each fixture. Once complete, energize power to all fixtures, they should turn on to full brightness. If fixtures do not go to full brightness, check wiring and consult ballast installation installing unit inside a junction box please see Application Note #423. Once installed, energize the PowPakTM Dimming Module and all fixtures. Fixtures will start at high-end and one by one go dim when given an address.
Permanently install Wireless Transmitters 4 Note: Please consult individual component installation guides for information. Test Link When installing a PowPak
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: